Halo 4/5 Recon GEN-2 (Helmet only, for now...)

[Spartan092]

Hello 405th Community,

It is time I become active in this community. So here by, I'm showing my Recon GEN-2 Helmet, and the progress to the final result.

Pepakura assembly:
Standard printing, cutting and assembling

Hardening (Paper Mache & Bondo):
Since I've been doing this with a low budget, I'd first paper mached the whole helmet and then the bondo.

Paint & Visor:
Primer, Silver (for Damage) and Top Coat.

This is only the Helmet (for now). I'm planning to make a full Recon GEN-2 Armor, but couldn't wait to share this with you.

 

[Voren Marr]

Fantastic looking. Your armour will be amazing if following the same level of attention

 

[AFlyingPotato]

Would you be able to share the link to where you found the download to the pdo file? As i have looked everywhere and cannot seem to find it for the life of me. :/

 

[Spartan092]

Would you be able to share the link to where you found the download to the pdo file? As i have looked everywhere and cannot seem to find it for the life of me. :/

You are correct that you can't find it anywhere. I've unfolded it myself from a 3d model that I found about two years ago.

I have it uploaded on MediaFire:

Recon Helmet.pdo

 

[CrimsonViper97]

Hey looks good! The first helmet I ever wanted to make was the OG recon helmet and (although I haven't played that much of the new games) the new one looks just as cool. May be givin your files ago when I have access to my shop!