Reply to thread

Ummm.... Doesn't that printer vent though the bottom?  And you've got it on carpet it will sink in to.  I'd worry about dramatically shortening its life from fuzz and over heating.




An excerpt from my "New Armorer FAQ" but if I had to summarize:

It sounds like you might have jumped the gun by going straight to armor, and a tighter fitting armor at that.


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top