Reply to thread

I have a stupid question.. I was hitting a model with the pepakura stick and saw the red lines of death in it. I dropped it into 3ds max and found the thing had a mess of overlapping polygons and internal geometry that can't be seen. Is there a way to turn the entire thing into a... more uniform model without the sloppily overlapping parts?



This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top