Reply to thread

Any of you try out MakePrintable? This is an online STL repair tool. It fixes non-manifold surfaces, intersections and flipped faces. It can also check for wall thickness and hollow out your models. Even Mac is supported.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top