Reply to thread

This video is about the ender 5 extruder tension spring. It should be identical to the ender 3 pro one. Most parts are easy to take apart and put back together but I would highly recommend getting a second opinion and/or talking with Creality before dismantling anything. [MEDIA=youtube]CVIupqEbjkQ[/MEDIA]


PLA prints better for me around 205c to 210c but I've not had this issue with my extruder.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top