Reply to thread

You can use however much your slicer lets you use. The whole bed will be heated, however you will likely find the bed has "margins" where the nozzle can't reach, and thus is unprintable. Also, if you're like me and have a glass bed held down with bulldog clips, you'll want to factor them in too as they can get in the way.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top