Reply to thread

Message

Good morning, everyone.
I've done prints before, but usually much smaller ones like weapons and smaller handheld props. I'm trying to get into armor making, starting by attempting to print an ODST helmet, but I'm struggling with support. I'm using a CR-10S, which has a 300x300 build plate, so I can print the helmet whole, but my concern comes down to support placement and knowing which pieces need support and which don't. Has anyone ever printed an ODST helmet whole or even any helmet? Looking for a little guidance.

Any help is appreciated. I hate Cura

[ATTACH=full]350417[/ATTACH][ATTACH=full]350418[/ATTACH]

[QUOTE="Alriar, post: 846461, member: 56859"] Good morning, everyone. I've done prints before, but usually much smaller ones like weapons and smaller handheld props. I'm trying to get into armor making, starting by attempting to print an ODST helmet, but I'm struggling with support. I'm using a CR-10S, which has a 300x300 build plate, so I can print the helmet whole, but my concern comes down to support placement and knowing which pieces need support and which don't. Has anyone ever printed an ODST helmet whole or even any helmet? Looking for a little guidance. Any help is appreciated. I hate Cura [ATTACH type="full" width="657px"]350417[/ATTACH][ATTACH type="full" width="343px"]350418[/ATTACH] [/QUOTE]

This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification