Reply to thread

Message

Cura certainly does have its quirks. Have you had a look into PrusaSlicer? It's what many other slicers are based off nowadays, and you can setup custom printer profiles, so it'll work on Creality gear too!

[URL unfurl="true"]https://www.prusa3d.com/page/prusaslicer_424/[/URL]

I use BambuLab now (I have a CR10s but now just use the P1P) and I'm fairly certain it's based off of Prusa's software.

[QUOTE="PlanetAlexander, post: 846475, member: 33276"] Cura certainly does have its quirks. Have you had a look into PrusaSlicer? It's what many other slicers are based off nowadays, and you can setup custom printer profiles, so it'll work on Creality gear too! [URL unfurl="true"]https://www.prusa3d.com/page/prusaslicer_424/[/URL] I use BambuLab now (I have a CR10s but now just use the P1P) and I'm fairly certain it's based off of Prusa's software. [/QUOTE]

This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification