Reply to thread

Good! I printed the helmet already but decided to reprint a slightly larger size just for comfort. The forearms came out awesome and I finished the initial sanding for them! I did finish the torso as well but haven’t started sanding. Then my AMS broke so I’m going to take it apart to get the stuck filament out so if anyone has tips for that then I’d gladly welcome it! How are your prints going?


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top