Reply to thread

If you can't remove the visor then you can try spraying it with chrome in the helmet. I've done this with a helmet of mine and it turned out fine. Although it may be difficult if you have a helmet with a smaller opening. Just be extra careful to try and make sure you coat the visor evenly and you always spray directly on to the surface of the visor, not angled.


This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top