Ended 3 V2 Neo heating issue

I'm wondering if the heater is experiencing a drop in current. I'd make sure the connections for your thermistor and heater cartridge are solid on both ends.
 
I wonder if anyone might have an idea what's wrong on the discord server in the #3d Printing channel. I usually get pretty good advice from there
 
This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top