Reply to thread

Message

I have been working on an EOD helmet for the past few months and only now realized the is doesn’t want to hold together because I printed it too thin and the glue has very little material to grab onto, is there a way to fix this or should I try reprinting the helmet with thicker walls??

[QUOTE="SpartanMech1, post: 854103, member: 57171"] I have been working on an EOD helmet for the past few months and only now realized the is doesn’t want to hold together because I printed it too thin and the glue has very little material to grab onto, is there a way to fix this or should I try reprinting the helmet with thicker walls?? [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification

Forums
Costumes and Props
Halo Costumes and Props
EOD helmet