Reply to thread

Sharing your excitement because those parts look beautiful, cannot wait to see what it looks like all assembled! You mentioned that these are Galactic Armory files; how has your experience with the thigh pieces been so far? When I tried to print them it seemed as if the thickness between the inner/outer walls would cause issues when standing straight, but yours seem to work out just fine so far. Also, did GA provide the visor as well or did you get that from another vendor (or did you make it yourself?) Stunning work so far, greatly looking forward to the finished product!


This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top