Reply to thread

Message

just started to print the inserts so they should be done by lunch tomorrow. after i get home from school i will make sure they fit in the vambraces and if so, i can sand, paint, and then attach them to the rest of the vambrace. then i will do the final weathering touches on the vambraces and they will be complete.

I do plan on putting a few coats of clear coat on all the pieces, and maybe some clear vinyl, kinda like the stuff you would use in a cricut machine, on the high contact areas just so no paint comes off. i have seen Frankly Built use this on his MK39 Starboost Iron Man suit and it looks like a good idea.

[QUOTE="TorrinNorixius, post: 834468, member: 51405"] just started to print the inserts so they should be done by lunch tomorrow. after i get home from school i will make sure they fit in the vambraces and if so, i can sand, paint, and then attach them to the rest of the vambrace. then i will do the final weathering touches on the vambraces and they will be complete. I do plan on putting a few coats of clear coat on all the pieces, and maybe some clear vinyl, kinda like the stuff you would use in a cricut machine, on the high contact areas just so no paint comes off. i have seen Frankly Built use this on his MK39 Starboost Iron Man suit and it looks like a good idea. [/QUOTE]

This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification