First Spartan Build Update!

Thread starter OldManC
Start date May 28, 2024

OldManC

New Member

May 28, 2024

Hey! Its been a while and I have some news! I have started to trace some of my templates onto foam and will start to cut out those soon. However, I did have to move my workstation to a different area. I needed a monitor to view the models while I cut them out. So although the desk has less room, the trade off for the monitor is worth it. Anyway, I'll try to keep posted on here in the next few weeks and keep y'all updated.

This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.