Reply to thread

Message

Wanted to break the updates up so it wasnt one post bogged down by so much images.

[ATTACH=full]347507[/ATTACH]

Other barrel pokey thingy (Delta told me what it was and it was something to do with gas exhaust or something for the rounds to chamber themselves but i forgot the name of it lol)

[ATTACH=full]347508[/ATTACH]

More detail for the top of the rifle cause I didn't like the look of it before and those back stripes were wonky...

[ATTACH=full]347509[/ATTACH]

Finishing up the barrel for details. Instead of cutting grooves into the PVC like i wanted to I just put strips of 2mm foam on them in an equal spacing to imitate it.

[QUOTE="Shadowshail, post: 843175, member: 5515"] Wanted to break the updates up so it wasnt one post bogged down by so much images. [ATTACH type="full" width="449px"]347507[/ATTACH] Other barrel pokey thingy (Delta told me what it was and it was something to do with gas exhaust or something for the rounds to chamber themselves but i forgot the name of it lol) [ATTACH type="full" width="399px"]347508[/ATTACH] More detail for the top of the rifle cause I didn't like the look of it before and those back stripes were wonky... [ATTACH type="full" width="399px"]347509[/ATTACH] Finishing up the barrel for details. Instead of cutting grooves into the PVC like i wanted to I just put strips of 2mm foam on them in an equal spacing to imitate it. [/QUOTE]

This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification