Reply to thread

Message

[ATTACH]330077[/ATTACH]First time contributing, have the 9.5x40mm cartridge, the ammo used for the Battle Rifle. Three files: One time the bullet with bottom engravings, which is intended for resin printing, but I suppose with a nozzle smaller than .4 you could get the details ok-ish done. Other two files are the same bullet, but without the engravings, and an empty shell without engravings too. Would add an empty shell with engravings but Fusion being Fusion won't let me.

[QUOTE="ODST 422, post: 826055, member: 46789"] [ATTACH]330077[/ATTACH]First time contributing, have the 9.5x40mm cartridge, the ammo used for the Battle Rifle. Three files: One time the bullet with bottom engravings, which is intended for resin printing, but I suppose with a nozzle smaller than .4 you could get the details ok-ish done. Other two files are the same bullet, but without the engravings, and an empty shell without engravings too. Would add an empty shell with engravings but Fusion being Fusion won't let me. [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification