Reply to thread

Message

I haven't done anything new with the 2nd prop. It's still at the same point from my last post.
But...
Today was Foam Clay day!!!!
There are a tonne of visible layer lines and uneven spots. So I pulled out my tub of foam clay and started slapping the stuff on.
Why does it always look so ugly after it's applied???
Now to let it cure for at last 24 hrs and then sand it smooth.
[ATTACH]346361[/ATTACH][ATTACH]346362[/ATTACH][ATTACH]346363[/ATTACH][ATTACH]346364[/ATTACH]

[QUOTE="PaiganBoi, post: 842324, member: 25559"] I haven't done anything new with the 2nd prop. It's still at the same point from my last post. But... Today was Foam Clay day!!!! There are a tonne of visible layer lines and uneven spots. So I pulled out my tub of foam clay and started slapping the stuff on. Why does it always look so ugly after it's applied??? Now to let it cure for at last 24 hrs and then sand it smooth. [ATTACH]346361[/ATTACH][ATTACH]346362[/ATTACH][ATTACH]346363[/ATTACH][ATTACH]346364[/ATTACH] [/QUOTE]

This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification