Reply to thread

Now that I got my scaling pretty much down doing some clean up. I print with a large nozzle size ( currently both my FDMs are running 1.0 nozzles). Also i am printing in Petg. So I have been extremely happy with some of the smaller details quality on this helmet


This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top