Reply to thread

yeah so I’m 3d printing a B-01 Helmet from Helldivers and I thought I’d post updates here. (Gotta get that member status you know?)

Any and all advice for anything and everything would be helpful if you have something to give btw, I love constructive criticism.


This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top