Reply to thread

My snaps tutorial works with 3d prints, so long as you use a strong adhesive for the nylon straps attached to the snaps (such as shoe goo or fiberglass

good write up [USER=55548]pinoyfiasco[/USER]


This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top