Reply to thread

I've actually got one of those VuFine displays kicking around, that was my original idea but I figured because you need a proper raspberry Pi to run the whole show it'd be nicer to just have a small microcontroller. You should be able to run my entire system with a single MicroUSB cable and it'd draw maybe 250-500mA. a little less involved and less like a "linux computer in your helmet" and more of a self contained HUD/sensor system on a single board.


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top