Kamen Rider BLADE helmet (pics)

[tomahawknutter]

hey everyone, been wanting to make a kamen rider helm for quite a while now and i will be honest it hasnt gone well so far
1st of all i didnt scale it right :/ i know where i went wrong, i forgot about the huge spike on top and included that into the mesaurements, if i had of left it out it would have fit.
so this will just be a model on my shelf, still its a learning curve aint it
another problems i had was attaching the front, the face and the eyes to the helmet, there isnt any indication as to how it should be done, so i just had to guess and used way too much tape :/ at least it wont matter when i but bondo and that on it.

so at the moment i have pepped it, and ive added resin on the outside, also rondoed the inside but pics of that will follow later as i need to add another layer as this was way too thin.

 

[tomahawknutter]

worked on it a little past few days, at the mo ive added bondo, sanded, primed, added spotting putty and resanded and primes ready to add putty where needed again,
only posting 4 pics, got loads but gona save them and make a video and post at the end

 

[puchinpurin]

hope i dont get verbally annihilated for bumping a seven month old thread but great progress on the blade helm! did you ever finish it?

 

[tomahawknutter]

haha, at least ya honest

na i didnt mate, jesus 7months old ???? didnt think it was that long

i didnt scale it right, my intention was to eb able to wear it, this wouldnt fit a kid, my scaling skills back then were shocking, i also got my green power ranger helmet at that time and started to work on that