Reply to thread

Message

Finally got around to finishing the cockpit door.

[ATTACH]268698[/ATTACH] [ATTACH]268699[/ATTACH]

Hung it in place and even have a system that holds it open! Did some work drilling and wobbling the mech and it stayed open. It wobbles because one leg is half an inch longer than the other D:

[ATTACH]268700[/ATTACH] [ATTACH]268701[/ATTACH]

And I had some fun with DIY stencils

[ATTACH]268702[/ATTACH] [ATTACH]268704[/ATTACH] [ATTACH]268703[/ATTACH] [ATTACH]268705[/ATTACH]

Almost ready for the con, just gotta submit my paperwork and rent that trailer (hopefully borrow a ball from my folks when I visit easter weekend).

[QUOTE="GMer56, post: 766648, member: 3019"] Finally got around to finishing the cockpit door. [ATTACH]268698[/ATTACH] [ATTACH]268699[/ATTACH] Hung it in place and even have a system that holds it open! Did some work drilling and wobbling the mech and it stayed open. It wobbles because one leg is half an inch longer than the other D: [ATTACH]268700[/ATTACH] [ATTACH]268701[/ATTACH] And I had some fun with DIY stencils [ATTACH]268702[/ATTACH] [ATTACH]268704[/ATTACH] [ATTACH]268703[/ATTACH] [ATTACH]268705[/ATTACH] Almost ready for the con, just gotta submit my paperwork and rent that trailer (hopefully borrow a ball from my folks when I visit easter weekend). [/QUOTE]

This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification