Reply to thread

Mounting the optical system on a boom with a smaller screen so it's easier to install n stuff (rubber band is temporary until a part finishes printing).


[ATTACH]281195[/ATTACH][ATTACH]281196[/ATTACH]


Doing some modelwork for the Promo armor:


[ATTACH]281197[/ATTACH]


This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top