Reply to thread

Hold on this is brilliant. Let me make sure I understand. So there is an imprint on each side of the cube matching the exterior of the shoulder and the interior of the pauldron. This creates a slot for each of the actual pieces to nestle into and create more area to glue/bolt. Super awesome I was wondering how I was going to do this!


This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top