Reply to thread

Small update - the Morrigan helmet is finished. Props to TitlewaveDesigns for such an easy print! I love the functional vents on the face mask - makes it easier to breathe and keep the inside of the helmet cool. On to sanding. At this point all pieces have gotten a metal coat and are ready to get masked off for weathering.


[ATTACH=full]352874[/ATTACH]



This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top