Reply to thread

Message

The prints have been completed**

[ATTACH=full]339875[/ATTACH]

** Minus some gaskets and pieces that I want to experiment with flexibles for.

A few weeks ago I wanted to try to get this suit to this point by the end of the year. I barely made it (last piece finished ~8 PM tonight)

There were a few pieces that tried to make me miss the goal, but I got it done!
[ATTACH=full]339876[/ATTACH]

Now on to the part that I hate the most - getting everything ready for paint.

[QUOTE="MrJamin, post: 834816, member: 39477"] The prints have been completed** [ATTACH type="full"]339875[/ATTACH] ** Minus some gaskets and pieces that I want to experiment with flexibles for. A few weeks ago I wanted to try to get this suit to this point by the end of the year. I barely made it (last piece finished ~8 PM tonight) There were a few pieces that tried to make me miss the goal, but I got it done! [ATTACH type="full" width="317px"]339876[/ATTACH] Now on to the part that I hate the most - getting everything ready for paint. [/QUOTE]

This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification