Reply to thread

Here is the post where I mention everything I learn about printing with that armor:. Mark VI Mjolnir Powered Assault Armor GEN 3 - 3D Printed - Full Walkthrough



You are very close to finishing.  Really nice work.


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top