Reply to thread

Message

A few months ago, my cousin wanted in on the action and he decided to print his own Spartan. He went for a security look from Halo four and five. Together, we cast two sets of rubber suits using about 2 gallons of dragon skin plus a few pints for touchup areas. His armor was slightly less complex than mine in terms of rigging, and by the end of a week working together, we were able to get his 95% of the way done. You’ll see some shots of his work sporadically throughout my pics. It’s a cool comparison to see a glossy black ONI operative type lad next to my beat up green boi

[QUOTE="armoryofalbus, post: 855901, member: 59548"] A few months ago, my cousin wanted in on the action and he decided to print his own Spartan. He went for a security look from Halo four and five. Together, we cast two sets of rubber suits using about 2 gallons of dragon skin plus a few pints for touchup areas. His armor was slightly less complex than mine in terms of rigging, and by the end of a week working together, we were able to get his 95% of the way done. You’ll see some shots of his work sporadically throughout my pics. It’s a cool comparison to see a glossy black ONI operative type lad next to my beat up green boi [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification