Neck seal

Several members like SSGLordBert have 3D printed neck seals in flexible filament like TPU.

Others like marinesniper sculpted and then molded and cast neck seals in flexible rubber.

Others have utilized the Evil Ted pattern:

Others custom make their patterns using "Duct Tape Dummy" method:

And an older thread where you can see the pattern used, and might be able to transfer it from the image shown to your own paper.
 
Several members like SSGLordBert have 3D printed neck seals in flexible filament like TPU.

Others like marinesniper sculpted and then molded and cast neck seals in flexible rubber.

Others have utilized the Evil Ted pattern:

Others custom make their patterns using "Duct Tape Dummy" method:

And an older thread where you can see the pattern used, and might be able to transfer it from the image shown to your own paper.
Thank you
 


Write your reply...
This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top