Reply to thread

Started on the layer details and since I'm doing a build thread might as well put what thickness foam I'm using for said parts. I got the barrel, flashlight and what I'd assume a gas port in, only the barrel is set for now.


Magazine I took about 6-7mm off and layered 2/2mm and used N8tebbs way for magnets. The magnets are 1in neodymium cubes I inlayed into the gun and covered back up to make it flush. Details will cover the cuts


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top