Reply to thread

Hello! This post is related to my ODST build, but since it's 6 months old, and this is more of a question, I'm just posting a new thread.


Recently I decided a recon helmet would be sick for an ODST, and I'm almost ready to paint it, I just have a few more sanding passes to smooth it out before it's ready, but I digress.


Attached below are a few pictures of the pattern I made in paint 3D, it's pretty rough, but this is only meant to show the colors in their general spots.


[ATTACH=full]357890[/ATTACH]


[ATTACH=full]357891[/ATTACH]


[ATTACH=full]357892[/ATTACH]


[ATTACH=full]357893[/ATTACH]


Any feedback on the patterns would be greatly appreciated, as well as suggestions and ideas!


Have a wonderful day!


This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top