Reply to thread

Fitting everything together now while learning how to sew. Fortunately, it’s just webbing and figuring out how everything should connect together.


After testing walking with the leg Armor, I realized the shins would give way to gravity, so I connected them to the thigh Armor with two connecting points on either side of the knee. Next is going to be building the belt and a full harness so that the legs can be supported by it, and the rest of the Armor as well.


The forearms are tight enough to stay put with just the foam.


Here’s a test fit. Knee popped off so I’ll need to add more reinforcements such as screws


[ATTACH=full]353462[/ATTACH]


[ATTACH=full]353463[/ATTACH]


[ATTACH=full]353464[/ATTACH]


[ATTACH=full]353465[/ATTACH]


[ATTACH=full]353466[/ATTACH]


[ATTACH=full]353467[/ATTACH]


[ATTACH=full]353468[/ATTACH]


[ATTACH=full]353469[/ATTACH]


[ATTACH=full]353470[/ATTACH]


This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top