Reply to thread

Hello everyone. I still need to purchase Armorsmith, but I plan to start my 1st 405th build soon! I plan to 3D print MoeSizzlac's files for Rookie from Halo 3 ODST.[ATTACH=full]350347[/ATTACH]

I have a brand new Ender 3 v3 KE that I plan to print parts on.


This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top