Reply to thread

Wanted to show the end result of my waist piece. It's separated into 4 sections the front, the two side and the butt plate. The butt plate is attached to the sides via velcro straps that are held in place by hot glue. Then I use parachute clips to attach the front piece to the sides. It looks a bit wonky at certain angles but I think it turned out pretty good. [ATTACH=full]356159[/ATTACH][ATTACH=full]356160[/ATTACH]

Thank you all for the help it was extremely helpful for my build


This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top