Reply to thread

Ahhhhh. Good thing to know about that. Now, I just need to remember if I need to make the sheet slightly bigger than the box. I also need to figure out if I need to have the vacuum insert hole from the side or down. I think that the vacuum I have may not be enough... More investigation is needed.


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top