Reply to thread

Good gravy.....you could print a full height me in that thing!  :oops:


I appreciate the offers everyone!  Mine is SUPER basic and not big.  I got an Anycubic Kobra 2 Neo.    It said it was the best intro printer for kids to get in to 3D printing so I hoped it wouldn't be too difficult for me.  :D Plus, I liked the auto bed level.  I'm not looking to print a whole suit, although I would LOVE to print a Riz set of armor but that's for another time and a different printer.  For now I want to print bits and pieces - the detail bits.


This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top