Reply to thread

::update:: 7/7/24


Very small update from last post. Got my belt done. So all that’s left is the gloves. Which will have a test shortly after I get a boot printed for [USER=49040]SSGLordErne[/USER] done on my bambu printer. I got everything laid out on my pvc mannequin to see it all together. Then realized I missed a white stripe on my left thigh. So I took care of that after the photo was taken. Once everything is ready, I’ll be finishing prints for the others and then padding/test fitting. 


[ATTACH=full]349900[/ATTACH]

[ATTACH=full]349901[/ATTACH]


This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top