Reply to thread

Message

Anyone using the FLSUN V400? I’m getting ready to start on a full Master Chief build and need a new printer. I’ve had a PRUSA i3 Mark 3 s for several years (3800 hrs of build time) and did a full Mando suit plus a bunch of stuff on my Dalek but it won’t cut it for this build even though it’s an amazing printer!
I’ve narrowed it down to the FLSUN or AnyCubic Kobra Max 2. I like the idea of a Delta printer when going at fast speed vs the large bed slingers but I don’t know if 300 x 300 x 410 is ‘big enough to print everything but the chest armor piece as one piece?

Also I’m really partial to the PRUSA slicer but currently their is no profile for the FLSUN. Not sure if there I one for the AnyCubic?

[QUOTE="Nimitz, post: 837845, member: 54118"] Anyone using the FLSUN V400? I’m getting ready to start on a full Master Chief build and need a new printer. I’ve had a PRUSA i3 Mark 3 s for several years (3800 hrs of build time) and did a full Mando suit plus a bunch of stuff on my Dalek but it won’t cut it for this build even though it’s an amazing printer! I’ve narrowed it down to the FLSUN or AnyCubic Kobra Max 2. I like the idea of a Delta printer when going at fast speed vs the large bed slingers but I don’t know if 300 x 300 x 410 is ‘big enough to print everything but the chest armor piece as one piece? Also I’m really partial to the PRUSA slicer but currently their is no profile for the FLSUN. Not sure if there I one for the AnyCubic? [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification