Reply to thread

Message

Printer Name: Commonly called 'WTF?' but technically called Creality Ender 3 v2
Bed Size: 220x220x250mm
What I've printed on it: not much. A few small projects.

I initially purchased it so I could learn and then eventually print the S7 to complete my weapons wall. I have struggled with it though so I took a break from trying. I'm going to start the learning process again soon. I didn't think the learning curve would be so difficult but I'm sure I'm making it harder than it is.

[QUOTE="GingerBiscuit, post: 838511, member: 51782"] Printer Name: Commonly called 'WTF?' but technically called Creality Ender 3 v2 Bed Size: 220x220x250mm What I've printed on it: not much. A few small projects. I initially purchased it so I could learn and then eventually print the S7 to complete my weapons wall. I have struggled with it though so I took a break from trying. I'm going to start the learning process again soon. I didn't think the learning curve would be so difficult but I'm sure I'm making it harder than it is. [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification