Reply to thread

Message

True. In reconsideration, I think I'll just make the main pieces out of EVA, and only 3D print the more detailed pieces. The only piece of armor I may have to fully print due to complexity is the helmet, which can be sliced into about 12 pieces. Thankfully, my helmet prints won't be too large. Thanks for that! (as I probably would have tried to 3D print the whole suit if not for that)

[QUOTE="Fadeout751, post: 840806, member: 55429"] True. In reconsideration, I think I'll just make the main pieces out of EVA, and only 3D print the more detailed pieces. The only piece of armor I may have to fully print due to complexity is the helmet, which can be sliced into about 12 pieces. Thankfully, my helmet prints won't be too large. Thanks for that! (as I probably would have tried to 3D print the whole suit if not for that) [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification