Reply to thread

Message

If you've made it this far you've read a lot of advice about "Just buy a BambuLab machine, they're turnkey".
And most of those advices pre-date the very recent firmware update announcement.
Its worth noting that BambuLab is currently in a firestorm of PR nightmare after announcing their upcoming firmware is going to make changes to lock out a lot of features-block 3rd party slicers like the very popular OrcaSlicer and so on.
I'm not saying 'Don't get one'... Just saying 'You should at least be aware when making your decisions'.

[MEDIA=youtube]91kfolYkRNM[/MEDIA]

[QUOTE="SgtSaint, post: 852087, member: 48265"] If you've made it this far you've read a lot of advice about "Just buy a BambuLab machine, they're turnkey". And most of those advices pre-date the very recent firmware update announcement. Its worth noting that BambuLab is currently in a firestorm of PR nightmare after announcing their upcoming firmware is going to make changes to lock out a lot of features-block 3rd party slicers like the very popular OrcaSlicer and so on. I'm not saying [I]'Don't get one'[/I]... Just saying [I]'You should at least be aware when making your decisions'[/I]. [MEDIA=youtube]91kfolYkRNM[/MEDIA] [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification