1st Build 3D Printed Mk V(B) Build - First build!

Lookin sick ! for my boots, I just used adhesive to glue elastic onto each of the plastic pieces, so that I could take the armor pieces off and on the boots. It doesn't look terrible with the boots underneath either. Not 100% accurate, but also pretty comfortable for the most part, which is also important. Hope this helps in some way !
 
This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top