Eagle strike!

[halo three rat]

After I realized that my last attempt at armor kinda failed and had no idea what I was doing, I decided to start working on a suit of armor that I knew would look good, so I found some eagle strike photos online and based my armor off that.

Then I scaled and sliced all the pieces, so now all I have to do is print them. I’m printing them in order of largest to smallest, so I. Printing the chest piece right now, then I’m going to move to the helmet, then the calves, the forearms, then the thighs and last with the little pieces like the shoulder, knees, hands, etc.

 

[CTN04529]

How do you plan on rigging the whole thing together?

 

[halo three rat]

How do you plan on rigging the whole thing together?

I plan on gluing straps to sanded parts of the print. Might try something else if that doesn’t work, but I haven’t put too much thought into how I’m going to strap them together yet.