EOD helmet

[SpartanMech1]

I have been working on an EOD helmet for the past few months and only now realized the is doesn’t want to hold together because I printed it too thin and the glue has very little material to grab onto, is there a way to fix this or should I try reprinting the helmet with thicker walls??

 

[SgtSaint]

Its done. Don't invest $100 to fix $30 in reprint.

Also... This is why in my FAQ, I recommend starting on smaller things until you learn the art+science that is 3d printing. Then after that you start armor down at the feet with helmet last. Figuring out your settings, strengths and so on over half a dozen helmets is going to be expensive and time consuming. Learn on learning models, then small props, then bigger props, and the very specialized genre of wearable armor after you level-up your printing and scaling skills.