HOW TO PRINT A2 ON PEPAKURA

T

TR0GD0R

New Member
Hello squad- Im trying to make a Terminator Space Marine from Warhammer 40k and for the life of me cannot figure out how to print in A2 in Pepakura. The image is attached, any advice is appreciated! (is it even possible)
 

Attachments

  • pepakura.jpg
    pepakura.jpg
    1.7 MB · Views: 40
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

B
Pepakura Space Ships
Replies
0
Views
269
BynumBoggs
B
HunterM
Beginner cosplayer seeking advice on building a Metroid cosplay
Replies
1
Views
11
spartan114x
spartan114x
Thirstycrusader
Destiny 2 Breachlight 3d print
Replies
0
Views
477
Thirstycrusader
Thirstycrusader
Lazzapp
  • Locked
How Should I Connect My Suit?
Replies
5
Views
1,102
Lazzapp
Lazzapp
SamuelHan
Avatar Na'vi Knife
Replies
3
Views
840
Wendi82
Wendi82

Similar threads

B
Pepakura Space Ships
Replies
0
Views
269
BynumBoggs
B
HunterM
Beginner cosplayer seeking advice on building a Metroid cosplay
Replies
1
Views
11
spartan114x
spartan114x
Thirstycrusader
Destiny 2 Breachlight 3d print
Replies
0
Views
477
Thirstycrusader
Thirstycrusader
Lazzapp
  • Locked
How Should I Connect My Suit?
Replies
5
Views
1,102
Lazzapp
Lazzapp
SamuelHan
Avatar Na'vi Knife
Replies
3
Views
840
Wendi82
Wendi82
Back
Top