Mk 7 helmet Fixing

Thread starter JDTV
Start date Jun 16, 2024
Tags

#3d print halo infinite cosplay mk vii

JDTV

New Member

Jun 16, 2024

So after 3 weeks of going on and off BC of work my Mk VI helmet is finally done, only issue is that it's missing a couple edges and stuff which I don't know how to fix them, plus for the groves and parts that need even a bit of infill I don't think spot putty even exists where I live in Spain, Amazon is even more useful none the less, my farther recommended I use Bostic (a glue like silicone but 100 times stronger and can we exchanged with other glues) or some fine resin, from my experience idk if in a couple years time I will need to change the Bostic due to heat making it release or not even work with paint or primer, need quite a bit of help with this one

This thread is more than 8 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.