Reach update

[PapaSola]

so nearly a year later and I’m finally getting around to printing the torso to my Mark V(B) cosplay, I’ve been busy traveling and working so I haven’t had time to focus on any costumes but with WASummerCon2023 coming up in June I want to get as much finished as possible and then after I have gotten the first set of goals done I can go onto customization aka shoulder attachments and any else like so.

 

[Catsbegaming24]

Looks very nice so far! What grit of sandpaper do you happen to be using?

 

[PapaSola]

Looks very nice so far! What grit of sandpaper do you happen to be using?

Using 60 and 220

 

[Catsbegaming24]

Using 60 and 220

Ok, thank you!

 

[Shadowpi3]

so nearly a year later and I’m finally getting around to printing the torso to my Mark V(B) cosplay, I’ve been busy traveling and working so I haven’t had time to focus on any costumes but with WASummerCon2023 coming up in June I want to get as much finished as possible and then after I have gotten the first set of goals done I can go onto customization aka shoulder attachments and any else like so.

Ive seen this armor before xD cant wait to see it all done!

 

[PapaSola]

so nearly a year later and I’m finally getting around to printing the torso to my Mark V(B) cosplay, I’ve been busy traveling and working so I haven’t had time to focus on any costumes but with WASummerCon2023 coming up in June I want to get as much finished as possible and then after I have gotten the first set of goals done I can go onto customization aka shoulder attachments and any else like so.

Finally coming around to give the costume some attention, giving it a new “flat black” paint job and finishing up some prints for it, hopefully I’ll have it fully ready before ECCC