Allright this is what i did for the cone
I decided to make the cone smaller than the one used in the series just because i wanted to use less material
These are the templates i used
http://img.tapatalk.com/d/14/07/20/3agezu3a.jpg
I traced the base on 1/2 inch thick foam
And the "cone" section on a 5mm thick foam, i folded the template in half and traced it 4 times (1/2, 1, 1, 1/2) on the foam in order to get a Round edge on the cone, then i put. Everything together
http://img.tapatalk.com/d/14/07/20/eraqu4a3.jpg
I then used 2 coats of wood glue on the inside to add some strength to the cone
Then did 2 coats of acrylic orange paint on the cone, lightly sanded the cone and pained it again with another voat of orange, then i added the white line and finally did some dry brushing to weather the cone a bit, after this, i was done
http://img.tapatalk.com/d/14/07/20/ga3y5ury.jpg
Next week i will be doing the shins and then i may have to buy some more foam for the boots, again, give me your opinion on wich dog tag should i do
Comments and criticism are most welcome
Later